Gear change clunk.
2 posters
Page 1 of 1
Gear change clunk.
Can anybody help please.
I have a Bandit 1250A/SA
When I start off from cold and select 1st it's nice and smooth. Going along changing up and down is also smooth.
But. When I stop at traffic lights, roundabout etc and put the bike in neutral then select 1st it's one hell of a clunk and sometimes it's like the bike surges forward.
Any help would be appreciated.
I have a Bandit 1250A/SA
When I start off from cold and select 1st it's nice and smooth. Going along changing up and down is also smooth.
But. When I stop at traffic lights, roundabout etc and put the bike in neutral then select 1st it's one hell of a clunk and sometimes it's like the bike surges forward.
Any help would be appreciated.
mike1949- Posts : 12
Join date : 2015-04-28
Age : 74
Location : Chippenham, Wiltshire, UK
Re: Gear change clunk.
first thing i would look at is bleeding out all the old clutch fluid , replacing it with new , 15 min job , then possibly an engine oil chance , i found the Castrol Actevo works well on my 1200 Bandit
samcro- Posts : 25
Join date : 2014-11-24
Age : 57
Location : South Africa
Re: Gear change clunk.
Cheers Samcro, will give your suggestions a try.
mike1949- Posts : 12
Join date : 2015-04-28
Age : 74
Location : Chippenham, Wiltshire, UK
Similar topics
» engine clunk at low revs in nuetral
» usd fork change
» Flat spot in acceleration after air filter change
» mk1 1200 wont rev past 8k rpm in top gear
» gsf1200 bandit 2001 stuck in first gear
» usd fork change
» Flat spot in acceleration after air filter change
» mk1 1200 wont rev past 8k rpm in top gear
» gsf1200 bandit 2001 stuck in first gear
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|