Carb mixture screw adjustment.
2 posters
Page 1 of 1
Carb mixture screw adjustment.
I have a 1200 k2' I have a venom exhaust, it runs a bit lumpy under 3000 rpm, I have set both outer carbs at 5 turns out which has greatly improved it, should I try and struggle to do centre carbs or leave as, I don't know what they are set at. Any help appreciated.
Hondavee- Posts : 2
Join date : 2014-07-22
Re: Carb mixture screw adjustment.
First of all set them all the same, I adjust them by taking apart a 4 in 1 screw driver and hold just the flat head bit and spinning them.
I'm pretty sure they are supposed to be set 2 turns to 4 turns if it runs better further then that, your slow speed jet is too small. Could also happen if your intake air boots are cracked.
I'm pretty sure they are supposed to be set 2 turns to 4 turns if it runs better further then that, your slow speed jet is too small. Could also happen if your intake air boots are cracked.
homernukem- Posts : 7
Join date : 2015-04-26
Similar topics
» How far should I break down my carb rack?
» Carb Cleaning Cost?
» carb float bowl required..
» 2001 carb body switch
» looking for 2002 1200 bandit carb parts
» Carb Cleaning Cost?
» carb float bowl required..
» 2001 carb body switch
» looking for 2002 1200 bandit carb parts
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|